Pursuit Boats Owners Forum

Dan1

Charlie,
I made replacements out of 316 stainless, very simple to do,I may still have one,if if I do its yours for free I will get back to you in a few days,need to have a look for it.

Dan1

I brought it from westmarine several years ago, I pulled out the original and its electronics, and inserted the led in its place. You may want to start working all the screws with WD40 and gently tapping them, some of them may strip the heads, refit them with some marine grease on the threads. If yo...

Dan1

[/quote] You have any pictures of the hidden fasteners you used?[/quote]

I think so (it was done many years ago) I will have a look for them when I'm home on the weekend

Dan1

First pic pic taken from the other thread. In the center of the grill on the inside I layered up glass at either end to thicken up the area where the bolts where to be fitted and drilled a small hole from the outside. (Red X’s in pic of grill’s removed) Then countersunk the hole’s on the outside so ...

Dan1

Glad to help (if it helps) I glassed that through hull up and moved it up above the waterline and tore out all the PVC on the inside, it should not have been used below the waterline..... Have a close look at the anchor locker drain,Pursuit used a plastic push in fitting that cant be sealed from the...

Dan1

Tried reseting the ground fault on the outlet above the sink? Does it have power?

The outlet in the bathroom is on its own circuit( with its own ground fault) the other two (hanging locker and above the sink) are on the same circuit.

Dan1

The low pressure alarm switch is prone to failure, dont bother with the cheap aftermarket ones available from autoparts stores, they cant handle the vibrations of the 4cyl diesel. You can test the switch simply by pulling off the single wire, the alarm should stop, the switch is located next to the ...

Dan1

Those mounts look classy, nicely done!

Dan1

Nice work Mark, you should patent the exhaust support bracket! For those who have the larger holding tank (as does mine) it does come out as well, its no easy task but it can be done with diesels and a generator in the E.R. Mine leaked from brand new it had a hole in the forward part of the tank, ha...

Dan1

Woodworker2001 wrote:Qr Bbpost
Dan1 wrote:
What in the world would cause them to pull power from the bilge pump breakers and through the stereo breaker on the panel. I still have yet to figure that one out…

I changed that years ago, not sure what they where thinking...

Welcome to Pursuit Boats Owners Forum

Search found 20 matches

Express 3000 Exhaust Tip

Hardtop courtesy light

Another 3000 Express Engine Vent Repair

Another 3000 Express Engine Vent Repair

Another 3000 Express Engine Vent Repair

3000 express 110 volt outlet issue

Alarm

Engine mounts worked!!!

Hatch Lifters

99 Pursuit express 3000 stereo wiring