2460 Denali - Water in the for area not draining to aft bilge

[hnt]

Probably coming from the hull- top cap joint along the rub rail. It is not uncommon for water to come in at the joint in heavy seas if the seal is compromised. You might want to call the factory to get their opinion on a fix. You can likely remove the rub rail and inject 3M 5200 using a calk gun. I once looked at a 2460 that had a leak at the rub rail that would get the monkey fur material in the cabin wet in choppy seas.

Good luck!!!

[anchor out]

hnt - 7/1/2013 9:13 PM

Probably coming from the hull- top cap joint along the rub rail. It is not uncommon for water to come in at the joint in heavy seas if the seal is compromised. You might want to call the factory to get their opinion on a fix. You can likely remove the rub rail and inject 3M 5200 using a calk gun. I once looked at a 2460 that had a leak at the rub rail that would get the monkey fur material in the cabin wet in choppy seas.

Good luck!!!

"MONKEY FUR" :hysterical:

[Rman]

Same problem here 2460 Denali 2004. Is there an answer to the mistery or these boats are just made to ride wet... definitely the bilge pumps will have to be checked regularly... lots of $ spent on coroded engine parts...