Welcome to Pursuit Boats Owners Forum

We are a boating forum for owners of Pursuit Boats to enthusiastically discuss all aspects of Pursuit Boat ownership. Whether you are looking for your first Pursuit or currently own one, you are sure to feel at home on PursuitBoatOwners.com

You are currently viewing our boards as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

2005 3370 Offshore battery box replacement

If you have a project idea or a completed one you would like to show off (major or minor)? Share it with the rest of us!

Topic author
ricksphd
Junior Member
Posts: 2
Joined: Sat May 09, 2020 2:24 pm
Vessel Info: 2005 Pursuit 3370, twin Yamaha Four Stroke 250's
Has thanked: 1 time

2005 3370 Offshore battery box replacement

Postby ricksphd » Wed Nov 18, 2026 12:06 pm

When I bought this boat in 2020, the only ding on the survey was some rot on the bottom of the battery compartment. I lived with it… until now. The batteries are sagging as the rot has gotten worse (of course). I cut out the old floor but it seems it was essentially hung from the vertical walls (also rotting in the bottom where a fiberglass corner tab joins them to the floor piece). So I am cutting all the rot out and trying to figure out the best way to connect a new vertical wall to the remains of old one tree hat is now too short after cutting the rot out. And I cannot support it from the bottoms because the fuel tank is below it.

If anyone has done this before I would be curious how you did it. I’m thinking of screwing an overlapping patch plate to the vertical board, then glassing over it. I will need to mount new corners on the bottom of the vertical piece to support the weight of the new floor piece with two batteries on it. I’m thinking of screwing an aluminum angle bracket for that purpose.

Comments and suggestions welcome.
[img][img][/img][/img]
Only registered members can view attachments. Registration is fast and FREE!

Return to “The Project Center”



Who is online

Users browsing this forum: No registered users and 2 guests